Common Trouble Of Green Fodder Harvester And Its Solution

1. The stubble height is too high, over 200 mm.

Solution: Adjust the power suspension cylinder to the proper position and lock it tightly. If it still can't be solved, adjust the three-point suspension on the top

Suspension, in the case of ensuring that the transmission shaft will not break due to too large Angle, increase the cutter table inclination, so that the sawtooth blade cutting point down.

2. Cut the serrated blade to hard cracks or bend.

Solution: replace the original factory standard equipped with the serrated blade, the replacement method has been described above.

3. The service life of the triangle belt is sharply reduced and frequently damaged.

Solution: this is the relaxation of the belt friction smaller, adjust the support wheel support strength and support wheel in the transmission three

The relative position of the angle belt ensures that the support wheel is positively supporting.

4. Excessive weeds are mixed between the disk and the disk holder, affecting the harvesting.

Solution: cleaner failure. Increase the cleaner bend angle below the saw blade without touching other components

Degree, if the cleaner is damaged, replace the original factory standard parts.

5. The bellows enters the hard object, causing the blade to collapse and even the deformation of the knife plate.

Solution: if the blade damage is not large, easy to repair, adjust the distance between the blade and the fixed knife of 2~5mm. If the damage is too large,

Contact the manufacturer, purchase the original knife plate and blade, and reinstall them. If the damage is serious, replace the whole minced and kneading mechanism directly.

6. The hydraulic cylinder of the bin could work normally. After being placed for a period of time, it was found that it could not rise.

Solution: check whether the hydraulic oil is insufficient or the hydraulic oil is polluted, if the hydraulic oil is insufficient, if the contaminated fluid is replaced

Pressure oil

7. The direction control of the delivery mechanism is not flexible, and the direction control board can not be supported.

Solution: check whether the direction control line (stop line) is damaged, or the interface screw is loose, and replace the lock.

8. After the startup or during the operation of the equipment, the rotating mechanism has abnormal sound transmission, or abnormal heat.

Solution: check whether the bearing is damaged and replace the standard bearing.